This modern shaped self-contained china toilet emulates the European wall-hung toilets that are so popular as of late. The Sanistar can be used with a hand basin only. The wastewater of a hand basin drains into the toilet motor and after a certain amount of water has entered, the motor will start and pump away the wastewater. At the same time it will also partially empty the bowl, which after the motor stops, will be refilled with clean water.

The Sanistar saves space and can be hung on any sturdy wall. It comes complete with a wall bracket system that can be placed against a wall or if you start from scratch-it can be built into the wall and mounted against 2 x 6 studs. The wall bracket has feet that can be adjusted to allow the Sanistar to be hung at a height that is comfortable for the user user, for example between 15 and 18 inches. The Sanistar uses a minimum amount of water. The flushing mechanism is electrically timed to allow approximately 4 liters (1.1 USG) of water to pass through the toilet.

The Sanistar has no external water tank as the flushing mechanism is built in and is totally electric. After use, one presses a pneumatic button on top of the bowl, this activates a timer and a solenoid valve in order to fill and wash the sides of the bowl. The motor starts and the waste and paper are sucked inside, where it is macerated and pumped away. The motor stops after approximately 15 seconds and the timer programs the refill of the bowl with fresh water.

The discharge pipe of the Sanistar is 1 inch in diameter; the pump operates at 7 PSI and pumps the effluent upwards to 9 feet and/or 100 feet horizontally. The discharge pipe-work may be made with either copper or solvent welded plastic material, provided that a consistent gravity fall is maintained throughout the run. The Sanistar also allows for a hand basin hookup.

At the soil-stack end of the pipe run the small-bore pipe-work must be connected to the waste by means of an appropriate TY fitting. Electrical supply to the Sanistar is 120V, 15 Amp. The system should be connected to a Ground Fault Circuit Interrupter circuit.

LEGAL DISCLAIMER The Plumbingmall attempts to provide information which is correct and up-to-date.  However, errors do occur and therefore we do not  make any guarantees or warranties that the information on this web site is free of errors.  Therefore, when reviewing and/or using the plumbingmall web site, you must accept that the information on this web site is without any express or implied warranty that it is correct and that you accept the risk that the information on this web site may be incomplete or inaccurate. Additionally, the plumbingmall shall not have any liability for any direct or indirect damages, any direct or indirect incidental damages, or any direct or indirect consequential damages regarding any of the information on this web site.© Copyright 1995 - 2007 The Plumbing mall.com. All rights reserved. Reproduction in whole or in part in any form or medium without the expressed written permission of The Plumbing Mall is prohibited. All trademarks are the property of the respective companies.