|
#11 SaniCubic Classic
-
Bath
-
Bidet
-
Sink
-
Shower
-
Power Shower
-
Laundry Sink
-
Washing Machine
-
Dishwasher -
Toilet
2 Year Warranty
FREE SHIPPING
The Sanicubic Classic
is a pre-assembled heavy-duty grinder pump that meets the demanding
needs of commercial and residential sewage applications. The
two-grinder system in the SaniCubic are made of stainless
steel liquefies solids into small particles prior to being passed
through the 1-1/2” discharge. It is designed to handle multiple
waste fixtures for applications such as residential single or group
homes, commercial buildings, schools and many more. The SaniCubic
system consists of two 2-horsepower motors housed inside a compact
but highly durable plastic enclosure. Each independently operating
grinder has its own high-performance grinding system: a
fast-rotating cutting blade to reduce solids in the wastewater
stream from toilets, tubs and showers, sinks, washing machines,
dishwashers, etc
Free
Shipping to the contiguous united states |
SaniCubic Classic
The Sanicubic Classic operation is as simple as the
installation. The effluent enters the pump through one of five
different inlets – one on either side of the unit at the bottom and
three along the top. The inlets can accommodate 1-1/2” or 4”
diameter pipes. As soon as the wastewater level reaches the trigger
point, the pumping system activates. The effluent is then pumped out
through 1-1/2” diameter rigid pipe connected on the top of the pump.
Maximum pumping distances are 36 Ft vertically and/or 328 Ft
horizontally.
The inside of the Sanicubic Classic comprises of a couple of
pressure switches and a circuit board assembly, which starts and
stops the unit, and of a couple of motors, which drive the stainless
steel cutting blades and the pump. Water and organic waste matter
that enter the enclosure are reduced to slurry and are picked up by
the impeller mounted beneath the motor.
The two grinders inside the Sanicubic Classic are engineered
to operate alternately. They each take turns handling the wastewater
so that neither is more heavily used over time than the other.
However, if either pump ceases to operate, the other pump will run
full-time until servicing can eliminate the problem.
One of the many features of the Sanicubic Classic, is the
smart-pump operation. A single pump is able to handle up to 50
gpm. If the incoming rate is higher than the discharge rate, the
pump automatically signals the “overload” stage. This will activate
the second pump and both pumps will operate simultaneously until the
condition is alleviated. When both pumps are in operation, the
discharge rate increases roughly 80%. In this event, a visual alarm
LED on the unit will switch to red.
The wastewater from other sanitary fixtures is discharged into the
Sanicubic Classic via five 1½-inch or 4” inlets, on either
side of the housing and on the top of the enclosure. The internal
discharge pipes come equipped with check valves that prevent back
flow into the unit. Isolating valves (not supplied) must be
installed on waste inlets and on the discharge pipe to ensure that
any service/maintenance may be carried out safely.
The SaniCubic Classic has been designed with a 1-1/2” vent
connection on the top of the enclosure. All plumbing codes require
connection to a vent system. Please note that the vent system should
be a two-way air vent. The use of mechanical vents, air admittance
valves or similar devices are not permitted as these are considered
one-way air vent systems.
The Sanicubic Classic has been certified to American and Canadian
Standards. Macerating standard; US: ASME A112.3.4, CA: Macerating
Standard CSA B45.9
|
